 |
LL-STB-1 levelers are
quick and easy to install.
If you prefer, they can be pre-installed at the ladder
factory, or professionally installed by local ladder dealers and service
companies, such as Advanced
Ladders, Batavia
Services, Inc., Industrial Ladder, Nationwide Ladders
and Ladder Doctor (all
specialists in serving
utility companies).
If you should decide to
install them yourself, you will find it's a snap. The process requires
about 15 minutes and few common tools - a pen or pencil, center punch,
hammer, electric drill with two drill bits, and a
socket or box wrench. It's as easy as 1, 2, 3...
Mark the Hole Centers.
Position the template provided on the center line of the
ladder rail, near the bottom of the leg.
Using a felt tip pen or pencil, mark the 3 hole centers.
|
  |
Drill the 3 Mounting Holes.
Center punch the 3 marks made in Step 1.
Using a 1/8" drill bit, drill pilot holes in all 3 positions.
Insert a 11/32" bit in the drill and re-drill the
holes.
|
 |
Bolt on the LeveLok® Unit.
Slip the studs on the LeveLok unit through the holes you've drilled.
Slide washers and locknuts on the studs and tighten the
nuts with a 1/2" wrench.
|
 |
 That's all there is to it! In about 15 minutes, your
"ordinary" extension ladder will be
LeveLok-equipped and ready to use.
Your ladder will be able to adapt to terrain differentials
of up to 10 inches - without any effect on its duty rating.
And the new, heavy-duty feet will greatly enhance the
sure-footedness of your ladder, on any terrain.
Would you like more detail? Well, we wrote
The Book on installation of our Levelers - and you can get it as an
Adobe Acrobat PDF file simply by clicking here! (File size is approximately 1.3MB.)
|
